A blues town at the edge of the loess bluffs
Como is a small I-55 exit town in Panola County, with a historic downtown and a spot on the Mississippi Blues Trail. As a concrete contractor in Como, MS, we pour driveways, shop and barn slabs, and patios, and we coat and polish floors. New slabs run $5.32 to $15.61 a square foot, from a plain broom finish up to a shop slab built for a coating. Our Memphis team covers Como from up I-55.
Loess ground and local stone in Como
Como sits where the loess bluffs of Panola County drop off toward the flat Mississippi Delta to the west. Loess is a fine silt, and it washes out easily. It’s a different ground from Delta clay or river mud: wind-laid silt over older gravel terraces.
Loess doesn’t swell the way clay does, but it does shift if the base under a slab isn’t packed and graded right. So on any new pad, we check the compaction and the grade first. Get that step right and the slab holds. Skip it and the loess moves.
What stone and gravel goes into Como concrete?
The rock in a Como pour comes from the Memphis Stone and Gravel Perry Plant in Senatobia, over in Tate County. It’s chert gravel and sand, dug from the old Coastal Plain terrace beds north of town. Panola County sits on Eocene-era beds along the loess belt. It’s not the Tuscaloosa Gravels you find farther northeast near the Alabama line, and it’s not crushed limestone.
You’ll see that on a polished floor. A full-aggregate cut, which starts at 16 or 10 grit, grinds deep enough to show the stone. On a Como slab it reads as a warm cream field with tan, honey, and gray flecks, lighter and more mixed in color than a limestone grind. In a historic storefront or a farm-store interior, that tone fits the building.
What draws concrete work to Como’s old downtown?
Visitors who come for the blues history and the National Register downtown give the storefronts, churches, and restaurants there real foot traffic all year, and working farms ring the town.
Many of those downtown floors are original mid-century pours, and nobody knows exactly when they went in. We check every slab before we quote a coating, and an old slab of unknown age is a warning sign. On those, we run a moisture test before any epoxy or polyaspartic goes down. Water vapor pushing up from under old concrete will lift a coating, no matter how well we ground the top.
Old slab, new coating: test first
A moisture test takes a little time. The sealed kit sits on the slab for 48 to 72 hours before we read it. That wait on day one beats a coating that lifts in year two.
How much does new concrete cost for a Como driveway?
Our standard driveway quote is a 5 inch slab on a packed gravel base, with #4 rebar on 18 inch centers, a 4,500 PSI mix, and a spray-on cure. A two-car driveway of about 500 square feet runs $3,650 to $8,650 before the drive cost, which is our trip to your site. The low end is a plain slab with fiber and no sealer. A small driveway runs above the per-foot range, since setup spreads over fewer feet.
On any bid you get, 4 inches and 4,000 PSI with 4 to 6 percent air is the least you should accept. Loess moves when the base is loose, so we pack the gravel in layers before the pour. Driveway details
What else does our Memphis team pour and finish in Como?
Shop and barn slabs. Farm work around Como runs from detached equipment shops to full barndominium pads. A working shop carries heavier point loads than a home garage. So we size the rebar to the load, thicken the edges at the overhead doors, and lay a vapor barrier under any slab that will get a coating. If you plan to coat or polish it later, our Pour-4-Polish process means we write the pour spec for that finish. Shop slab details
Patios and outdoor flatwork. A patio sits on the same loess as the driveway, so the prep is the same. The finish is where you get choices: broom, exposed aggregate, or a stamped texture. Patio details
Garage floor coatings. We start a Como garage with diamond grinding, not acid etching. Our standard flake floor (RESA Flake) is an epoxy build: an 18 to 22 mil flake coat, then 16 to 18 mils of clear epoxy and a 4 mil urethane top. Polyaspartic is the premium build, priced on your quote. Shop and work-truck floors get a chemical-resistant build. Garage coating details
Polished concrete. Polish suits the downtown storefronts and churches that visitors walk through. The shine is ground into the slab itself, so there’s no film on top to peel. Polished concrete details
Get a Como price online
Answer a few questions about your project and the quote tool gives you a price. No waiting on a callback.
How does scheduling work for a Como job?
The quote tool gives you a price without a callback. Once you confirm the scope, our Memphis team puts Como on the North Mississippi schedule. The mobilization, our trip down I-55 with the crew and the gear, is its own line on the quote, so there’s no surprise later. After that, the slab sets the date. A new pour waits on its base and forms. An old floor that needs a moisture test waits on the result.
- Check the Mississippi service area for Sardis, Courtland, and other nearby towns.
